EnGenius ENH900EXT Manual do Utilizador descarregar pdf (Página 15)

1. Connect one end of the Ethernet cable into the main

LAN port (PoE) of the Access Point and the other end to

theAPEthernetportonthePoEinjector.

2. Connect the Power Adapter to the DC-IN port of the

PoEinjectorand plugtheotherendin toanelectrical

outlet.

3. Connect the second Ethernet cable into the LAN port of

thePoEinjectorandtheotherendtotheEthernetport

on the computer.

4. Screw on the provided antennas to the device. Once

both connections are secure, verify the following:

a) Ensure that the POWER light is on (it will be green).

b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will

be green for both 5 GHz and 2.4 GHz).

c) Ensure that the LAN (Computer/ENH900EXT

Connection) light is on (it will be green).

d) Once all three lights are on, proceed to set up the

Access Point using the computer.

Thisdiagramdepictsthehardwareconguration.

Note: TheAccessPointsupportsbothIEEE802.3atPoE

(Power over Ethernet) or the included power injector.

You may use either one as the power source. Do NOT

use both at the same time.

Hardware Installation

Ethernet

Power

Outlet

PoE Injector/

PoE Swtich

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Sem comentários

EnGenius ENH900EXT Manual do Utilizador Página 15